This article is all about common fillers used for DIY applications.
The classic example of this is "Polyfiller" a powdered plaster like filler that is mixed and applied. Sets to a hard long lasting finish that may be sanded to achieve a very smooth finish.
- Does not shrink much as it dries
- Sands well
- Takes paint and other finishes well
- Not flexible
- Not waterproof
- tough enough to put wallplugs into
A ready mixed acrylic water based filler that is ideal for filling difficult corners and cracks when decorating. Easy to work, and good for joints that may be subject to vibration and movement (e.g. along skirtings, door frames, into corners etc). Can be used to hide slight gaps between some sheets of wallpaper.
- Dries quickly and can be overpainted
- Can be removed with damp sponge while wet
- remains slight flexible to accommodate movement.
- Can't be sanded - must be tooled smooth when wet
- Shrinks a bit on curing, so not good for filling holes in walls.
Standard wood filler is an acrylic based mixture that's weaker than chipboard. If used in bulk the filler shrinks and cracks.
Linseed putty can be used as a harder tougher wood filler, but setting is extremely slow, and the filler must be undisturbed while it gradually sets.
Car body filler (polyester resin) is a tough durable quick setting filler used where good strength and prompt setting are necessary.
Car body filler
Car body filler is a 2 pack polyester resin with many DIY uses.
- filling steel window frames
- filling wood frames where high strength & durability are needed
- moulding detail sanding blocks
- repair pipe damage
- tougher replacement for 'no more nails'
- repair screw holes in kitchen cabinets & flatpack furniture
- cast small appliance parts
- car body repair
- repair rust holes in appliances
- repair small bits of damage to concrete (mix with sand for this)
A recent development in fillers is the introduction of 'lightweight fillers' sold under the brand names Red Devil ONETIME Filler, Everbuild One Strike, Wickes Fast Fill etc. They apparently contain lightweight polymer bubbles. These do not crack, shrink, or sag and require little or no sanding. They can be overpainted in 30 minutes or so.
Plaster gets used as filler. Its very cheap but doesn't behave as well.