Difference between revisions of "Snubber"
(cat) |
(→Component Values: 2) |
||
| Line 18: | Line 18: | ||
==Component Values== | ==Component Values== | ||
| − | The standard snubber is a 0.1uF capacitor and 100 ohm resistor in series, usually encased as one component. These values are good for the great majority of loads. | + | The standard mains snubber is a 0.1uF capacitor and 100 ohm resistor in series, usually encased as one component. These values are good for the great majority of loads. |
| − | Low current loads and heavy loads may need different values. Heavy loads will need a larger capacitor and lower resistance | + | Low current loads and heavy loads may need different values. Heavy loads will need a larger capacitor and lower resistance, low current loads may need smaller capacitor and higher resistance. |
| − | The snubber is simply connected across the switch. | + | The snubber is simply connected across the switch. In cases where an item is powered via multiple switches, the snubber can be connected across the appliance instead. |
==Help== | ==Help== | ||
Revision as of 05:05, 23 November 2008
A snubber is a small device that reduces switch arcing, thus avoiding premature switch failure.
When to use a Snubber
Snubbers are used with inductive loads which cause switch arcing. Examples of inductive loads:
- Mains motors (eg fans)
- Large transformers
- LPF (low power factor) iron ballasted Fluorescent Lighting (these usually flash during starting)
Most fluorescent ballasts have a built in power factor correction capacitor (PFC), making them HPF (high power factor). These don't need snubbers. LPF iron ballast fittings (with no PFC capacitor) do need a snubber, or will destroy switches prematurely. Some LPF fittings have built in snubbers.
Thermostats
Snubbers greatly reduce pitting and wear on bimetal thermostat contacts, thus eliminating a fairly common cause of setting drift. They also reduce the chance of them sticking on, again improving temperature control, reliability and longevity.
When not to use a Snubber
A snubber compromises the degree of isolation a switch provides. A 0.1uF snubber can pass 75mA rms on 240v mains, enough to give a serious shock, thus snubbers make switched lives still live when switched off. So snubbers are usually only used when required to ensure the switch continues to work properly. Hence the great majority of household switches don't have snubbers.
Component Values
The standard mains snubber is a 0.1uF capacitor and 100 ohm resistor in series, usually encased as one component. These values are good for the great majority of loads.
Low current loads and heavy loads may need different values. Heavy loads will need a larger capacitor and lower resistance, low current loads may need smaller capacitor and higher resistance.
The snubber is simply connected across the switch. In cases where an item is powered via multiple switches, the snubber can be connected across the appliance instead.
Help
If you dont know whether to use one, you can ask us in news:uk.d-i-y.
For most switches they're not needed. When they are needed, repeated premature switch failure will occur if one is not fitted, as well as sparking and radio interference when switching.