Stone Wall Double Internal Insulation
A double dry-lining project in a random stone-wall cottage
This was a refurbishment of an old cottage built with randon stone walls and a flagstone floor. The rear extension, the old scullery and outside toilet, were modernised to fit a study above and a kitchen below. On a steep hill, the lower half half of the kitchen walls were below ground level.
The inside of the stonework had been cement rendered and whitewashed decades ago, It had crazed cracks, rusty hooks, lumps and bumps, and no damp proof course or tanking membrane. The flagstone floor was uneven and cracked too.
Advice from builders and council building control was the usual mantras going back to tried and tested methods from the 1950's. Ignoring that, I approached it from an engineering viewpoint, I submitted the design that follows and the response was that it was "not an approved system" so I would have to get it reviewed and approved by an architect. Ignoring that too, I fired the building control service and went ahead anyway. I'm not selling up in my lifetime, and it will deter the asset-strippers after I'm gone that no regularisation will be possible without a lot of pain. The new walls are fine after 4 years of my occupation here, I have no worry about the success of my project so far.
As a DIY project, I have much time, enough money, but want to save on complicated installation and sub-contracting. I also wanted very good insulation. The final calculation gave a U-value for the walls of 0.19