Search results

Bar-type thermostatic shower mixer valves are cheap and readily available. However they can be fiddly to install. Thi * [[Install Bar Shower Valve - in solid wall, copper pipe|in a solid wall, with rigid copper pipew

...for installing a concealed shower valve into an already tiled and finished shower, without disrupting the tiles or finish. ...er control, and it continued to supply water at a frantic dribble. Service valves had to be pressed into action to finally shut it off, and its replacement o

...se hairwashing attachment pushed onto the bath taps, putting in a 'proper' shower is a popular DIY project. ..., to a multi-jet full-body massage shower with drencher heads and diverter valves in a walk-in enclosure in a wet room.

* Are there any pressure reduction valves? Where? * Are there thermostatic blending valves? Where?

...space. It does have a large cupboard, and this would make for a good-sized shower if it were re-purposed. ...and rebuild both rooms. Fortunately there is another fully working loo and shower room downstairs in the house, so that will take some of the time and logist

...water, plus central heating pipework. A liberal deployment of crappy gate valves kept the working system isolated from the loft until it came to join it up. ...pipework was brought up to enter the loft through the floor where the new shower is shown on the plan above.

;[[Cement mixing|Cement mixer]] ...have a tap-connector outlet at right angles to the inlet. Washing machine valves are usually similar in construction, with a handle and with a 3/4" BSP male