Difference between revisions of "Fitting TRVs to Microbore"
m (Category:Energy Efficiency) |
|||
Line 30: | Line 30: | ||
| [[image:TRV_microbore_08.jpg|center]] | | [[image:TRV_microbore_08.jpg|center]] | ||
|- | |- | ||
− | | colspan=3 align="center" | Clean out the tapping in the radiator. A wet | + | | colspan=3 align="center" | Clean out the tapping in the radiator. A wet |
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− |
Revision as of 23:59, 4 July 2007
This article is about fitting Thermostatic Radiator Valves to microbore pipe used in Central Heating systems. It is equally applicable to fitting manual valves and lockshield valves when reworking or extending an existing microbore system.
The approach described here uses a standard 15mm valve and a soldered 15mm*8mm or 15mm*10mm fitting reducer (e.g. BES 6786 or 6787) to connect to the microbore. This avoids the difficulties that are likely to occur trying to fit a new 8mm or 10mm valve to existing pipework: because microbore copper is very soft the pipe is often found to be distorted when the old valve's olive is removed making it very difficult to get a good seal to the new valve. Even if the pipe is not distorted it is very easy to over-tighten microbore compression joints resulting in leaks. Because this method uses soldered joints the heating system must be drained down to below the level of the valves being replaced.
TIP: If planning to replace several valves on an existing system check the diameter of pipe on all valves to be changed: often systems have a mixture of 8mm and 10mm pipework.
Insert a fitting reducer into the valve so that the olive sits in the middle of the reducer (see pictures of the soldered-up connector, below) and tighten so that the olive grips the reducer. |
Line up the TRV body with the existing valve body and mark the microbore for cutting to fit into the reducer. |
Cut the microbore where marked: in this instance a junior hacksaw is used as there isn't space to use a wheel-type cutter |
Unscrew the old valve body and tail from the radiator (this saves undoing the valve from the tail and then using an L-shaped hex key to unscrew the tail). |
Clean out the tapping in the radiator. A wet |