Search results

• Roof construction
  ===With Gable walls=== ...ll plate. This is simply a timber beam that is fixed to the top of all the walls (typically by [[Nails|nailing]] through it directly into the brickwork belo
  12 KB (2,138 words) - 08:25, 26 January 2022
• Install Bar Shower Valve - in solid wall, copper pipe
  ...thod of installing a bar-type thermostatic shower mixer valve into a solid walls, using rigid copper pipework.
  3 KB (487 words) - 21:33, 27 June 2020
• Dovecot / Bird house build
  ...floor - with the top of it hitting the underside of the first floor). The walls were glued and nailed next. ...rop down far enough to allow the ground floor ceiling to sit on top of the walls.
  9 KB (1,638 words) - 00:06, 26 September 2019
• Intumescent Materials
  ...[[Putty & Mastic|putty]] fills gaps where [[Plumbing|pipes]] pass through walls. It allows pipe movement, and can be removed and reused if ever necessary.
  3 KB (392 words) - 01:25, 5 December 2014
• Heat loss
  ...happens. Most heat lost from a house is initially via conduction - through walls, floors, and ceilings. These losses will tend to heat the outer surfaces of * One can take into account the exposure of outside walls. More heat may be lost through one wall that is subject to high wind exposu
  30 KB (4,515 words) - 18:22, 30 September 2022
• Strengthen a Wood Floor
  ...ries of rectangular wood beams or joists, usually wood, which are fixed to walls at each end. Most timber joists are 2" wide, though 1.5", 3" and 4" are als ...from one point of view in ascii art, maybe a clear photo one day. Sleeper walls run at 90 degrees to the joists, and have holes to allow airflow.
  15 KB (2,432 words) - 05:52, 1 October 2014
• Problem Constructions
  ...roblems. [[Mortar Mixes|Cement]] render tends to cause [[Damp Links|damp]] walls, and when the cob reaches a certain level of water content, it loses its st
  3 KB (430 words) - 12:53, 10 August 2017
• Bunk bed
  * Omit 3 of the 4 uprights, fixing the woodwork to the [[Wall Materials|walls]] (in a corner). ...tion Wall|lightweight hollow plasterboard]] or [[Wall Materials|strawboard walls]], unless you can locate and fix to the uprights in the wall.
  8 KB (1,341 words) - 17:05, 19 March 2008
• Building a log cabin
  ...half a plank height, hence there are some half height logs for two of the walls that need to be used to start. ...height, you need to look for the half heigh finishing rows that bring the walls all out level at the same height:
  12 KB (2,122 words) - 00:35, 14 July 2018
• Installing multipoint air conditioning
  ...an isolated off-grid 1-bed cottage (no gas or oil) with random stone solid walls in SW England. The main heating was from an ancient wood-burning back boile ...-storey rear extension, bedroom over kitchen, facing south-east. The inner walls were cement rendered with a strong mix, hard, cracked, uneven and ugly. But
  8 KB (1,384 words) - 20:30, 18 March 2023
• Making Concrete Blocks
  This article is about making '''Concrete Blocks''' for good looking walls with character and quality. Anyone can make an ugly lump, but with a little * External Walls
  18 KB (2,929 words) - 22:39, 6 September 2013
• Expanding foam
  * Fills holes where [[Plumbing|pipes]] go through walls ...r/ solidifying. Misused as cavity [[insulation]] it can bring down masonry walls with its expansive force. Don't fill enclosed spaces with expanding foam, i
  6 KB (1,033 words) - 02:46, 2 May 2023
• Guttering
  ...ng gutter cleaning may result in interior [[Damp|wet patches]] on upstairs walls, exterior staining on [[wall]]s, and in some situations can [[rot]] flat [[
  10 KB (1,615 words) - 19:13, 10 November 2016
• Carpet laying
  ...ound the floor perimeter, leaving a gap of about 1/4" between grip rod and walls. The [[Nails|pins]] point toward the wall, and the sloping edge goes neares ...action pulls the carpet very slightly. Don't cut the carpet at 2 opposite walls before fitting it to the gripper, as fitting it moves the carpet slightly.
  12 KB (1,971 words) - 16:47, 12 February 2012
• Shed
  ===Walls=== ...is controlled, for further dryness the shed must keep out rain laden air. Walls can be lined with any of polystyrene, DPM, OSB etc.
  20 KB (3,173 words) - 19:36, 27 January 2013
• Filler
  * Shrinks a bit on curing, so not good for filling holes in walls.
  3 KB (500 words) - 15:51, 28 June 2017
• Home owners instruction manual
  * which fences, hedges walls etc are your responsibility? * Any alterations of walls, doors and window openings even if you think they're "not structural"
  8 KB (1,230 words) - 17:29, 21 August 2022
• Bad Ideas - Floors
  ...lts may include [[Mould Basics|mould]] growth and rising damp in adjoining walls.
  3 KB (421 words) - 09:44, 13 August 2014
• Insulation and Condensation
  ...way the vapour when conditions allow it to evaporate, such as in insulated walls, where a vapour barrier is essential. However, you can usually get away wit
  4 KB (717 words) - 00:46, 9 January 2022
• Papercrete
  ...Making Concrete Blocks|making blocks]], [[Sheet Materials|panels]], poured walls, roofs, plasters, [[Mortar Mixes|renders]], paving, pond liners, etc.
  3 KB (509 words) - 17:08, 19 March 2012

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)