Difference between revisions of "Garden table - slatted top"
(Outline article) |
|||
| (16 intermediate revisions by 2 users not shown) | |||
| Line 2: | Line 2: | ||
==Introduction== | ==Introduction== | ||
| + | My main objective in doing this project was to use up some leftover pieces of wood. The wood at hand consisted of some 2 x 2 inch, a 4 x 4 fence post, 3 x 2 railing from a fence and some old bed slats. The design was therefore constructed from what I had available. | ||
| + | ==Construction== | ||
| + | |||
| + | ===Building the table top=== | ||
| + | |||
| + | I decided on an octagonal shape using the 2x2 timber with an approximate `diameter` for the octaganol and then used an on-line calculator to determine the length of each side. Before cutting to size I used a circular saw to cut out a shoulder which would allow the slats to sit flush with the octagonal frame. | ||
| − | + | Using a chop saw set at 22.5° the angles required to form the octagon, as there were 8 sides this would be 22.5° for each angle. These were glued and screwed together. | |
| − | + | Next I added a cross frame to support the table top and for attaching to the top of the plinth using a simple cross halving joint. I addition I attached blocks of wood at each of the internal octagonal joints to add some strength (screwed and glued) | |
| − | [[ | + | [[File:shoulder.jpg]] |
| − | |||
| − | [[ | + | [[File:slat top B.jpg]] |
| + | ===Building the plinth and base=== | ||
| + | For the plinth I used a piece of 4 x 4” fence post and for the base 2 pieces of 3 x 2”. I made a half lap joint for the legs and the table top support and at the base and top of the plinth I cut a pair of perpendicular bridal joints. | ||
| + | [[File:plinth.jpg]] | ||
| + | [[image:PedestalTableLegCut.png|512px]] | ||
| + | [[image:PedestalTableBaseSplay.png|512px]] | ||
==See also== | ==See also== | ||
Latest revision as of 19:50, 10 August 2016
Introduction
My main objective in doing this project was to use up some leftover pieces of wood. The wood at hand consisted of some 2 x 2 inch, a 4 x 4 fence post, 3 x 2 railing from a fence and some old bed slats. The design was therefore constructed from what I had available.
Construction
Building the table top
I decided on an octagonal shape using the 2x2 timber with an approximate `diameter` for the octaganol and then used an on-line calculator to determine the length of each side. Before cutting to size I used a circular saw to cut out a shoulder which would allow the slats to sit flush with the octagonal frame.
Using a chop saw set at 22.5° the angles required to form the octagon, as there were 8 sides this would be 22.5° for each angle. These were glued and screwed together.
Next I added a cross frame to support the table top and for attaching to the top of the plinth using a simple cross halving joint. I addition I attached blocks of wood at each of the internal octagonal joints to add some strength (screwed and glued)
Building the plinth and base
For the plinth I used a piece of 4 x 4” fence post and for the base 2 pieces of 3 x 2”. I made a half lap joint for the legs and the table top support and at the base and top of the plinth I cut a pair of perpendicular bridal joints.
