Difference between revisions of "Sawboard"
Jump to navigation
Jump to search
(buenos dias, please check http://nj-escort.com) |
m (Reverted edits by 74.73.36.172 (Talk); changed back to last version by JonFairbairn) |
||
| Line 3: | Line 3: | ||
[[image:sawboard.jpg]] | [[image:sawboard.jpg]] | ||
| − | + | ===Tips on constructing a sawboard=== | |
| + | * mark the factory edge of the board before cutting it | ||
| + | * make the board wide enough that theres room to clamp it without getting in the way of the saw’s motor. This can be done either by making the guide part wide enough or by extending the lower strip extend out the other side. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
==See Also== | ==See Also== | ||
Revision as of 11:49, 16 March 2010
A sawboard is a guide used with a circular saw for making long cuts, particularly out of large board material, more accurately than by following a pencil line. The effect is similar to using a rip guide but whereas a rip guide might allow one to make cuts up to, say, 100mm from the edge of the material, a sawboard does not have this limitation. The device can be made out of two strips of wood (which have to be quite accurately cut in the first place) and is specific to the dimensions of the circular saw and blade kerf it is made for. A suitably-made sawboard can also be used with jigsaws.
Tips on constructing a sawboard
- mark the factory edge of the board before cutting it
- make the board wide enough that theres room to clamp it without getting in the way of the saw’s motor. This can be done either by making the guide part wide enough or by extending the lower strip extend out the other side.