Talk:Electrical Installation

Great work guys! Hopefully this is the right place for me to write the following;

I've just gone through with my own minor tweaks & saved them. Below are some suggestions for additions which I don't yet have the time or skill to insert & lay out neatly. Perhaps someone else might approve of them & decide to enter the suggestions themself? They are only in rough form & need re-wording.

• Mention in the Lifting Floors section that, when lifting boards by prying, it will often 1st be made easier by removing any stubborn nails or screws where possible. Nails or screws with damaged heads that can't be removed even with screw-removing bits, can be drilled down over the top of with a small holesaw of ~10mm diameter, through the full thickness of the board. The board can then be lifted, & the nail or screw with the ~10mm cylinder of wood that it goes through will remain in place. When replacing the board, new screws can be fitted alongside the old positions. <Photo for clarity>

• When needing to cut access holes in solid/ chipboard, besides the Trend Routabout jig mentioned, one can use a (eg. 110mm diameter) solid board access holesaw, which fits onto drills (widely available inc. on eBay). It has 2 concentric blades which cut a hole with a rebate. The hole can be closed later with corresponding plastic covers which sit on the rebate, perfectly flush with the top of the board. <Photo for clarity>

• Mention that sometimes larger, hand-hole sized access holes have to be made in hollow/ plasterboard walls (& ceilings). Describe the technique of cutting out a neat rectangle, & then how to patch the hole, involving fitting a short board or similar behind the hole, to create a back surface on which to fit the new piece of replacement plasterboard. <Photo for clarity>

• Use better, & less photos to show the volt stick in action. (I can't make out what I'm supposed to be seeing in the existing photos!)

• Include a good torch in the tool list - "very handy". For peering into holes, crawling in attics/cellars, & for when the mains lighting is out! I just love my pocket sized torch with CREE type LED - with floodlight brightness!

• Include a cable tracker & tone generator kit in the advanced test gear list - "handy". For locating cables behind boards & panels, singling out the correct cable from a bundle of them, & for finding the break in a cable. (Also useful for testing multiple-speaker installations etc). <Photo for clarity>

- Ax

Thanks for the comments Ax. I have included most of them into the article now, plus a few extra bits they prompted me to remember! The volt stick one, yup I see what you mean - I think part of the problem is the model being demo'd is Tim's rather snazzy one with not only live wire detection, but also proximity indication. I may do some photos of my rather more mundane "lights up / beeps when it detects something" one.

Cable tracker etc I will add when I have some suitable photos... --John Rumm 04:43, 13 April 2009 (BST)