Search results

Jump to navigation Jump to search

Page title matches

Page text matches

  • You would need to chase out the wall, set the pipes in position, and then plaster it all back in again. Would you need to wrap the pipes with denso tape or plaster straight onto them?
    898 bytes (168 words) - 18:37, 28 October 2008
  • File:ASHP pipe run.jpg
    external pipes
    (480 × 640 (88 KB)) - 17:17, 19 October 2021
  • File:PTFEWrappingGas.png
    Method for wrapping PTFE on threaded pipes for GAS work.
    (686 × 935 (26 KB)) - 22:08, 7 September 2011
  • File:Pipe exits to heater.jpg
    two sets of pipes before installation. They protrude towards the right where the unit will ha
    (494 × 556 (22 KB)) - 21:49, 30 October 2021
  • ...nd ceilings, and inserting [[cables]] for electrical supply and [[plumbing|pipes]] for [[water]] supply. ...fixtures are connected to the [[cables]], sinks and baths connected to the pipes, and [[Hanging a door|doors]] fitted into doorframes. Second fix work requi
    1 KB (205 words) - 23:09, 12 June 2008
  • File:Pasta pipe 5890-2.jpg
    Pipes :)
    (1,236 × 212 (81 KB)) - 22:42, 26 August 2012
  • '''Pipes for refrigerant''' * larger but similar DIY systems use 3/8 and 1/2 inch pipes ... if 1/4 inch is "straightforward" and 3/8 inch is "difficult but possibl
    2 KB (388 words) - 22:41, 29 October 2021
  • ...roup/uk.d-i-y/browse_frm/thread/af950a45f562b0b3?hl=en# Decorating exposed pipes]
    851 bytes (132 words) - 11:17, 18 November 2011
  • ...ontal distance from the axis of pipe '''B''' to pipe '''A''' (i.e. if both pipes were longer, how far would they be apart horizontally?). ...es are in line with edges of the box, and the coupling section between the pipes joins opposite corners of the box:
    3 KB (532 words) - 10:49, 14 January 2022
  • Box the pipes in. This provides a physical barrier to sound transmission, and creates a v ...nto the ceiling either side of the pipe. Not recommended for incoming cold pipes due to possible condensation.
    5 KB (782 words) - 03:29, 31 July 2020
  • ...ng Stairs|staircase]]. There is a gas meter and a maze of rusty [[Plumbing|pipes]] that run in all directions. There is a [[:Category:Pests|dead mouse]]. Th > exa pipes
    4 KB (770 words) - 22:46, 24 September 2022
  • ...nd flashing work. Historically it was also commonly used for water and gas pipes. Although much of this has been replaced with more modern materials, there ...pipe diameter in inches. The weight is specified pounds / yard. So heavier pipes of a given internal diameter achieve the same flow rates as lighter ones, b
    8 KB (1,377 words) - 10:49, 6 April 2023
  • ===Not checking where [[Cables|wires]] & [[Plumbing|pipes]] are before [[Nails|nailing]] flooring down===
    3 KB (421 words) - 09:44, 13 August 2014
  • == More on plastic pipes from elec FAQ == Earthing Plastic Pipes
    5 KB (832 words) - 06:35, 17 May 2013
  • ...I had to run pipe around a window unfortunately. Doesn't look so neat. The pipes down from the ceilings I put on the left side of the units and covered in P ...ft the rest to the F-gas fitters. Took 2 man-days for him to braise up the pipes, flush with nitrogen, fill with refrigerant, pressure test and connect the
    6 KB (1,072 words) - 11:08, 14 January 2022
  • ...or decades. I chipped a bit away to find no corrosion. Lots of houses have pipes in floor concrete, but resulting leaks are very rare. ...it's a myth that smoking is harmful. FWIW I have several times seen copper pipes buried in concrete that are corroding. It's generally accepted that this ma
    8 KB (1,445 words) - 22:41, 26 August 2012
  • ...ou need 400mm of vertical pipework on the left side. This is two insulated pipes, usually in black foam wrap and about 26-28mm diameter. Exposed it looks ho ...drilled the left two at an angle sideways to reduce the bend on the copper pipes behind the unit, the 3rd on the right square to the wall and angled slightl
    6 KB (1,050 words) - 20:14, 18 March 2023
  • [[File:Dsci0392.jpg|thumb|metal studs with pipes through them|link=http://wiki.diyfaq.org.uk/index.php/File:Dsci0392.jpg]]Th ...ght in coils. My small system needed 1/4 and 3/8 inch piping (metric water pipes can't be used) and joins cannot be made with solder, they must be braised.
    8 KB (1,384 words) - 20:30, 18 March 2023
  • ...range of products which includes multi-layer AluPEX pipes and 5-layer PEX pipes. Their founder (Chris Ingram) is Chairman of the Technical Committee of the
    6 KB (830 words) - 01:13, 7 February 2011
  • * running electricity cables or electrical fittings near gas pipes * removing walls supporting gas pipes, meters or appliances
    9 KB (1,433 words) - 11:22, 11 May 2010

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)