Search results

Jump to navigation Jump to search
  • ...used to seal the the gland against the cable. Beware that the compression ring (the thing that looks a bit like an "olive" in a plumbing fitting) might ha ...rnal glands only), next the main armour fixing nut, and finally the fixing ring:
    20 KB (3,549 words) - 13:55, 5 August 2022
  • ...o broad categories: Ring final circuits (often incorrectly referred to as "Ring Mains") and Radial circuits. The effects of the faults described above can ==Ring final circuits==
    23 KB (3,711 words) - 10:08, 3 August 2017
  • ==Ring Shanked Nails== [[image:Ring shank nails 150-4.jpg|right|250px]]
    9 KB (1,373 words) - 16:36, 12 October 2014
  • ...the first trick was to make sure I could cut the angles accurately on the ring. To test this I made some test pieces out of some very thin sections of scr ...with some traditional wooden hand screw clamps allowed the rather unwieldy ring to be pinned to the assembly table / table saw. The final draw bore pins co
    16 KB (2,788 words) - 01:16, 21 August 2023
  • ...s of the wall below needed to have the corners notched out so that the hex ring of the floor could drop down far enough to allow the ground floor ceiling t A repeat of the first floor, with an additional hex ring added to give more elevation to the roof, and act as a wall plate.
    9 KB (1,638 words) - 00:06, 26 September 2019
  • The ring of nylon creates friction, preventing the nut coming undone by itself.
    2 KB (388 words) - 16:40, 8 June 2020
  • ...ering come ready loaded with solder these are known as Yorkshire or Solder ring fittings. ==== Solder-ring ====
    15 KB (2,471 words) - 12:45, 24 January 2022
  • *[[Ring circuit]]s from 32A [[MCB]]s in the [[#CU|CU]] supplying mains sockets. 2 s ...m is shown with 6A [[:Category:Lighting|lighting]] [[Fuse|fuse]] and 32A [[ring circuit]] MCB. Other options are also possible:
    26 KB (4,100 words) - 00:12, 16 September 2021
  • | 2. || 32A || Ring 1 (kitchen)|| 32A || 100% || 32A | 3. || 32A || Ring 2 (downstairs) || 32A || 40% || 13A
    9 KB (1,368 words) - 21:41, 29 August 2016
  • As fluke would have it, a cable for the required ring circuit passed directly under the socket location, and even had enough slac
    3 KB (594 words) - 03:27, 9 January 2022
  • # Remove the sprung wire retaining ring that runs around the edge of the larger rubber door seal ...it sites snugly against the case front. Replace the sprung wire retaining ring when done.
    8 KB (1,437 words) - 14:02, 31 December 2019
  • * [[House Wiring for Beginners#Ring|Ring circuits]] usually use 32A MCBs,
    7 KB (1,227 words) - 10:28, 25 May 2023
  • It is not recommended to put an immersion heater on a [[ring circuit]]. The continuous 13A load leaves the circuit with reduced spare am ...commended to put an immersion heater on a 13A plug. As well as loading the ring it can cause plug overheating.
    8 KB (1,302 words) - 20:19, 8 September 2018
  • Ring low low med ===Ring Brackets===
    21 KB (2,706 words) - 11:27, 5 June 2012
  • ...tion is in the form of a ring, the earth connection must also complete the ring.
    11 KB (1,751 words) - 02:17, 6 September 2017
  • ...correctly. The nails in this case were 3.5mm thickness 95mm clipped head ring shank nails.
    5 KB (763 words) - 15:09, 7 June 2020
  • ...compression, pushfit or solder couplings (endfeed or yorkshire aka solder ring). Small holes can be fixed by soldering copper around them. Solder used on
    4 KB (732 words) - 01:09, 30 November 2014
  • ...se of the threading rod enables it to glide over rough surfaces. Close the ring rather than leaving it as a U shape to minimise the risk of it catching and
    9 KB (1,433 words) - 22:13, 21 July 2012
  • This does not apply to an all RCBO setup (other than the two cables of a ring might need to be placed next to each other). ...s tape the ends of each circuit together ie LNE of upstairs lights or if a ring tape them as a pair. Labelling the tape also helps as the tape will probabl
    19 KB (3,370 words) - 10:23, 25 May 2023
  • ...d some of the wiring loom with the display, and thumb throttle. The Silver ring being part of the pedal rotation sensor. ]] ...elf, or fixed to the seat tube on the frame. The disc typically contains a ring of small magnets, and the sensor a couple of hall effect detectors to sense
    26 KB (4,901 words) - 01:39, 28 February 2024

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)