Search results

• Sand
  ...works well blasted once, and some sand releases fine silica dust into the air when blasted, which can cause a lung health issue if used day in day out.
  4 KB (592 words) - 15:17, 6 April 2018
• Vehicle
  ...the key, wait 5 seconds for the tablet to boot, just like a computer. The air-con unit shows current cab temperature and you must choose to heat or cool. ...cover, so everything on the dashboard and in my tool-box got fired in the air and re-distributed. Then I had to adjust to pressing firmly on the brake pe
  7 KB (1,256 words) - 23:38, 17 February 2023
• Central heating design
  ...ation is not covered here. There is a discussion on updating existing warm-air systems [http://groups.google.co.uk/group/uk.d-i-y/browse_frm/thread/cd973d # The number of air-changes per hour expected for the room is found from a table
  25 KB (4,005 words) - 22:17, 4 November 2021
• Central heating flushing
  ...ons are more favourable for bacterial growth and there is contact with the air. Aerobic bacteria, fungi and slimes which have developed in the cistern can #Manually close any automatic air vents.
  16 KB (2,640 words) - 10:54, 17 February 2020
• Sanders
  non-existent, making use of dust masks or supplied air mandatory, and ...se holes often serve not only for extraction, but also a supply of cooling air for the sander. Block them with no punched paper and you may be rewarded wi
  12 KB (2,195 words) - 01:23, 16 October 2019
• Plumbing
  * refrigeration and air-conditioning * compressed air systems
  15 KB (2,471 words) - 12:45, 24 January 2022
• Insulation
  ...ousing. One way or another, each insulation product traps air, and its the air that does the job. ...ion value of 4" of material. In practice the change in size of the trapped air bubbles means that the value is affected slightly less than this.
  28 KB (4,332 words) - 23:28, 3 November 2021
• Vaillant Ecotec plus 624 repair
  First remove the plastic air duct - this is a push fit into the burner / fan assembly, and is retained b ...ts on the face of the burner. Remember to refit the bracket that holds the air duct under the top right fixing. The nuts have a positive end stop when tig
  23 KB (4,272 words) - 22:52, 7 August 2023
• Clean pewter
  ...aler. You can also have a dental hygienist take a go at it, because their Air-flow machines (miniature bicarbonate of soda sandblasters) are great for th
  5 KB (788 words) - 13:00, 21 August 2012
• Save energy
  Where goods are stored in the loft, boxed items trap air and thus have a little insulating value. ...ve lots of it, and the design of these windows often leads to them leaking air as well. Secondary glazing dramatically improves performance.
  20 KB (3,343 words) - 11:58, 24 September 2022
• Foam toolbox moulding
  Now, I sucked the air from bin liner. I used an injector pump and a bit of [[garden]] hosepipe at
  5 KB (973 words) - 15:35, 24 October 2017
• Microwave repair
  ...pically due to [[roof]] lining fixings coming out. The amount of force the air puts on the stirrer is slight, sometimes stirrers turn freely by hand, but
  16 KB (2,642 words) - 21:10, 11 November 2013
• Split-type Room Air Conditioner
  This is a write-up of how I installed a split-type room air conditioner for my office. This is my first installation of anything like t The split-type room air conditioner has two parts, an indoor unit and an outdoor unit, connected to
  51 KB (9,092 words) - 18:39, 4 November 2021
• Weather compensation
  ...t back up to the desired temperature. Modern well insulated and relatively air tight properties should loose heat less quickly than older draughty solid w
  7 KB (1,133 words) - 22:10, 1 November 2022
• Plastering Beginner's Guide
  ...detached and the drill run on full speed with no load to provide immediate air cooling - don;t just set it down and leave it.
  12 KB (2,279 words) - 23:47, 20 June 2018
• Solar PV example: single garage
  ...inclination would have the other short edge of the panel about 1.2m in the air. Such a setup would generate 1572kWh per annum according to GSA. Mechanical
  6 KB (949 words) - 14:08, 13 May 2023
• Raspberry Pi repair
  ...e very fine pitch surface mount resistors, I decided against using the hot air station, as the chances of finding one of those if I blew it off the board
  6 KB (1,102 words) - 13:28, 22 April 2023
• Making Concrete Blocks
  ...wrong way up. The concrete should then be tamped or vibrated to eliminate air pockets. Banging the mould with a shovel is the usual way. ...oncrete poured into the wall, and the poured mix poker vibrated to release air pockets. Each pour should be limited to 1m depth, and fall of the concrete
  18 KB (2,929 words) - 22:39, 6 September 2013
• Fridge
  ...its problematic to provide this, a quiet 3" or 4" fan can be used to move air upwards behind the machine (machines with side mounted cooling need side ai ...checking it grips a till receipt all the way around. A failed seal allows air to leak through, which results in excessive [[Damp|condensation]] formation
  26 KB (4,186 words) - 13:07, 12 September 2019
• Central Heating Controls and Zoning
  ...situation, but they can not balance a system effectively, as too large an air temp variation is needed to achieve the large degree of flow modulation the
  18 KB (2,996 words) - 12:00, 24 September 2022

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)