Search results

• Washing Machine Smells
  The key to the most effective detergents is to use a mix of chemicals, each compone
  3 KB (424 words) - 04:12, 9 February 2013
• Sealed system FAQ
  ...ts for a few pounds. B-W have introduced a new range which uses a smaller key but the comments apply. ...small key provided which operates through a quarter turn. If you lose the key a screwdriver will work fine (chubby version if access is limited). Some mo
  17 KB (3,123 words) - 00:17, 25 March 2014
• DIYFAQ History
  |+Key Dates
  3 KB (570 words) - 01:39, 11 February 2023
• Swimming Pool Steps
  ...sy, as well as a place to sit and paddle should the need take you. Another key requirement, was they must fold up for storage, so they can be wrapped in a
  4 KB (721 words) - 17:22, 5 August 2015
• Central Heating Operation
  ...little bleed screw at one end of the top of the radiator using a radiator key or pliers. Air will escape with a hiss, when the hissing stops and just wat
  4 KB (717 words) - 15:12, 7 April 2012
• Oil
  ...applied all round the key's stem, and the key pressed back in. After a few key presses the stem is then lined with a film of oil, and even unusably stiff
  21 KB (3,417 words) - 22:19, 27 April 2018
• Aerial amplifier
  ...ut can not undo loss of S/N ratio that has already occurred, and this is a key spec for picture quality.
  5 KB (868 words) - 09:26, 24 March 2014
• Replace a radiator
  [[image:Radiator key 4620-2.jpg|150px]] The radiators were all bled. Loosen the bleed valve with a bleeding key, air hisses out, once water begins to come out do it up again, not very tig
  11 KB (1,898 words) - 00:17, 13 December 2017
• Reciprocating saw
  ...e mechanism is also highly desirable (budget saws tend to require an Allen key for blade changes). A few saws also include an orbital blade action. This c
  6 KB (1,145 words) - 01:14, 21 September 2023
• Lawnflite 703 Autodrive blade clutch replacement
  ...inside of the hole through the clutch that you will need to align with the key way on the motor shaft.
  7 KB (1,173 words) - 18:56, 2 July 2022
• Drill buying guide
  ...ned at least as well or better than conventional chucks that require chuck key. The poorer keyless chucks are not as good as a keyed one in ultimate gripp
  7 KB (1,211 words) - 02:44, 2 May 2023
• Timber basics
  This article is a quick guide to the key concepts relating to timber. For more depth and further topics, see [[Timbe Grading is an assessment of the structural strength of the timber. Key features assessed in grading are splits and knots, especially large knots a
  16 KB (2,610 words) - 07:23, 18 March 2015
• Microwave repair
  ...ing of the behaviour of microwave rf is advisable if replacing magnetrons. Key safety issues are anything but obvious if you don't have such knowledge. ...hock. In a microwave oven the fuse performs an important extra role. Its a key part of the safety interlock system preventing users being microwaved. When
  16 KB (2,642 words) - 21:10, 11 November 2013
• Phone stand and desk tidy
  ...ike! The bottom drawer holds some banking card readers, and other security key devices.
  7 KB (1,382 words) - 10:16, 14 August 2023
• Threaded fasteners FAQ
  ...panner or socket extension can be pressed in to service to extend an Allen key. Application of a [[hammer]] (preferably rawhide or lead) or the heel of th ...ally impossible to drill. Some people prefer to hammer a sharpened hexagon key into a hole drilled in the end of the fastener, if ground flat at the end t
  18 KB (3,192 words) - 02:19, 6 September 2017
• Crack repair
  ...[screwdriver]] to make the crack wider and deeper. This creates a proper [[key]] for the filler, and also means you are using enough of the filler that it
  9 KB (1,504 words) - 08:44, 11 September 2019
• Drilling FAQ
  ...ut the bit into the chuck, and tighten it finger tight. Then use the chuck key in all three holes in turn tightening firmly, and then go round again in al ...k key built in to the drill, you can buy one from a tool shop, or keep the key in the chuck, or better still, tie it to the mains flex some 18" from the d
  32 KB (5,862 words) - 23:31, 30 August 2016
• Newsgroup access tips
  ...f in many different directions at once. (this thread "drift" is one of the key features of usenet groups than can make them both very interesting and at t ...t you will not see them as you advance to the next unread message when you key "n".
  22 KB (3,663 words) - 13:09, 14 January 2024
• Choosing a plug fuse
  The key to stopping this from happening, is to interrupt the current flow very quic
  12 KB (2,048 words) - 11:40, 17 August 2022
• Pattress
  ...the one box. Available accessories include various switches, [[dimmer]]s, key switches, indicators, etc. The accessories don't have any face plate, a sin
  12 KB (1,854 words) - 09:22, 15 June 2020

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)