Search results

Jump to navigation Jump to search

Page title matches

  • ...le:Ring circuit.jpg|thumb|343x343px|Diagram of a possible configuration of ring final circuit. Consumer unit is at bottom left.]] ...rcuit''' or '''ring circuit''' (informally also '''ring main''' or just '''ring''') is a wiring technique developed and used in the UK that uses two conduc
    17 KB (2,768 words) - 14:22, 28 June 2022
  • '''Final testing of a ring circuit''' ....g. a small ring with an excessive number of spurs, or a patched-up broken ring. Arguably, this is OTT for DIY, when you've put the cables in yourself, but
    2 KB (425 words) - 13:00, 19 October 2014

Page text matches

  • ==Ring circuits== ...terms ring circuits or ring mains and electricians often just use the term ring. (Lighting circuits aren't normally rings.)
    1 KB (180 words) - 00:24, 2 August 2017
  • '''Final testing of a ring circuit''' ....g. a small ring with an excessive number of spurs, or a patched-up broken ring. Arguably, this is OTT for DIY, when you've put the cables in yourself, but
    2 KB (425 words) - 13:00, 19 October 2014
  • ...ulled the [[fuse]]s an found the current was flowing in the [[ring circuit|ring]]. A
    1 KB (189 words) - 07:54, 3 April 2018
  • ...ckets to a ring circuit such that they are still fully integrated into the ring, but you are only required to make alterations at a single existing socket ...ry and pick a socket that only has two [[cable]]s connected (i.e. just the ring connections and no existing spur), and which has a reasonably deep [[Pattre
    3 KB (548 words) - 16:52, 9 January 2022
  • ==Ring & Radial Circuits== British socket circuits are always [[Ring circuit|ring or radial]]. A ring circuit makes a complete loop from [[CU]] (fusebox) to each socket and back
    7 KB (1,067 words) - 13:49, 4 November 2019
  • ...to hand. So I smeared a very little diluted linseed putty round the rubber ring & reassembled.
    2 KB (272 words) - 00:19, 23 July 2019
  • Some options to sort out a socket crammed with 4 T&E [[cables]], 2 for the ring and 2 spurs.
    1 KB (195 words) - 02:07, 13 February 2009
  • * [[Nails|Ring Shanked Nails]] * [[Nails|Annular ring nail]]
    3 KB (373 words) - 23:53, 29 September 2012
  • Mix [[sand]] & [[cement]] dry on [[Sheet Materials|board]]. Make a ring of the mixture. Add a little [[Water|water]] in the middle and fold the dry ...dry materials, then add [[Water|water]] and mix in. No need to maintain a ring of mixture to prevent [[Water|water]] escape, making it quicker.
    4 KB (613 words) - 03:36, 31 July 2020
  • ===Ring=== [[image:Ring spanner 319-7.jpg|thumb|Ring spanner]]
    7 KB (1,159 words) - 12:15, 16 December 2016
  • ...le:Ring circuit.jpg|thumb|343x343px|Diagram of a possible configuration of ring final circuit. Consumer unit is at bottom left.]] ...rcuit''' or '''ring circuit''' (informally also '''ring main''' or just '''ring''') is a wiring technique developed and used in the UK that uses two conduc
    17 KB (2,768 words) - 14:22, 28 June 2022
  • ...ar - Unlock. Common is from the positive + side of the power supply so The RING wire will only show a voltage when the entry button is pressed and -12V wil
    3 KB (542 words) - 22:27, 8 October 2022
  • ...ternal radius that is smaller that that of the router bush with its spacer ring fitted; and ...en any two sides must be no smaller than the outer diameter of the spacing ring.
    8 KB (1,444 words) - 14:32, 22 May 2020
  • New lock cylinders come with 2 snapoff screws, a front mounting ring and a rear fixing plate in the pack. Don't try snapping these screws, they ...Screw#Snapoff_screws|snapoff screws]]. Remove these, and the cylinder, the ring on the front, and often the plate on the rear all come away. Reuse these sc
    9 KB (1,536 words) - 00:59, 14 May 2017
  • In some cases its possible to reassemble a broken key ring and have the chuck then work fine long term. I did this once, and have had ...the chuck near the drill-ward end (don't [[clamp]] near the key tightening ring), ideally in a [[Clamp|vice]] in 2 indented bits of [[wood]].
    6 KB (1,056 words) - 13:34, 3 April 2011
  • * check its watertight after fitting, as its possible for the rubber sealing ring to sit wrong and allow leakage ...he fitting. Push the pipe into the fitting, and slide the seal and plastic ring up the pipe into the gap between pipe and socket. Now tighten the back nut
    9 KB (1,454 words) - 08:43, 8 January 2019
  • ...d-i-y/browse_frm/thread/98d87b4126fbab3b/ca15670fa85fc2ba#ca15670fa85fc2ba Ring circuit discussion]
    6 KB (1,068 words) - 08:10, 30 August 2016
  • Ring circuits introduced in 1947 ...210mm, Soft covers version, ISBN 0 85296 927 9, 1997 UKP 42 / US$ 84<br /> Ring-bound version, ISBN 0 85296 842 6, 1994 UKP 55 / US$ 110
    5 KB (753 words) - 12:42, 19 May 2022
  • A ring shaped omnidirectional antenna, these are very common. Less gain than direc
    4 KB (601 words) - 17:33, 1 August 2010
  • ...few turns of PTFE tape onto the base of the shaft and then refitting the O ring. This pushed it more firmly into the recess when the valve shaft was re-ins ...s. Once this arrived one could remove the packing PTFE tape, fit the new O ring (which was noticeably more supple than the old one), and reassemble permane
    15 KB (2,673 words) - 15:53, 5 May 2017
  • ...used to seal the the gland against the cable. Beware that the compression ring (the thing that looks a bit like an "olive" in a plumbing fitting) might ha ...rnal glands only), next the main armour fixing nut, and finally the fixing ring:
    20 KB (3,549 words) - 13:55, 5 August 2022
  • ...o broad categories: Ring final circuits (often incorrectly referred to as "Ring Mains") and Radial circuits. The effects of the faults described above can ==Ring final circuits==
    23 KB (3,711 words) - 10:08, 3 August 2017
  • ==Ring Shanked Nails== [[image:Ring shank nails 150-4.jpg|right|250px]]
    9 KB (1,373 words) - 16:36, 12 October 2014
  • ...the first trick was to make sure I could cut the angles accurately on the ring. To test this I made some test pieces out of some very thin sections of scr ...with some traditional wooden hand screw clamps allowed the rather unwieldy ring to be pinned to the assembly table / table saw. The final draw bore pins co
    16 KB (2,788 words) - 01:16, 21 August 2023
  • ...s of the wall below needed to have the corners notched out so that the hex ring of the floor could drop down far enough to allow the ground floor ceiling t A repeat of the first floor, with an additional hex ring added to give more elevation to the roof, and act as a wall plate.
    9 KB (1,638 words) - 00:06, 26 September 2019
  • The ring of nylon creates friction, preventing the nut coming undone by itself.
    2 KB (388 words) - 16:40, 8 June 2020
  • ...ering come ready loaded with solder these are known as Yorkshire or Solder ring fittings. ==== Solder-ring ====
    15 KB (2,471 words) - 12:45, 24 January 2022
  • *[[Ring circuit]]s from 32A [[MCB]]s in the [[#CU|CU]] supplying mains sockets. 2 s ...m is shown with 6A [[:Category:Lighting|lighting]] [[Fuse|fuse]] and 32A [[ring circuit]] MCB. Other options are also possible:
    26 KB (4,100 words) - 00:12, 16 September 2021
  • | 2. || 32A || Ring 1 (kitchen)|| 32A || 100% || 32A | 3. || 32A || Ring 2 (downstairs) || 32A || 40% || 13A
    9 KB (1,368 words) - 21:41, 29 August 2016
  • As fluke would have it, a cable for the required ring circuit passed directly under the socket location, and even had enough slac
    3 KB (594 words) - 03:27, 9 January 2022
  • # Remove the sprung wire retaining ring that runs around the edge of the larger rubber door seal ...it sites snugly against the case front. Replace the sprung wire retaining ring when done.
    8 KB (1,437 words) - 14:02, 31 December 2019
  • * [[House Wiring for Beginners#Ring|Ring circuits]] usually use 32A MCBs,
    7 KB (1,227 words) - 10:28, 25 May 2023
  • It is not recommended to put an immersion heater on a [[ring circuit]]. The continuous 13A load leaves the circuit with reduced spare am ...commended to put an immersion heater on a 13A plug. As well as loading the ring it can cause plug overheating.
    8 KB (1,302 words) - 20:19, 8 September 2018
  • Ring low low med ===Ring Brackets===
    21 KB (2,706 words) - 11:27, 5 June 2012
  • ...tion is in the form of a ring, the earth connection must also complete the ring.
    11 KB (1,751 words) - 02:17, 6 September 2017
  • ...correctly. The nails in this case were 3.5mm thickness 95mm clipped head ring shank nails.
    5 KB (763 words) - 15:09, 7 June 2020
  • ...compression, pushfit or solder couplings (endfeed or yorkshire aka solder ring). Small holes can be fixed by soldering copper around them. Solder used on
    4 KB (732 words) - 01:09, 30 November 2014
  • ...se of the threading rod enables it to glide over rough surfaces. Close the ring rather than leaving it as a U shape to minimise the risk of it catching and
    9 KB (1,433 words) - 22:13, 21 July 2012
  • This does not apply to an all RCBO setup (other than the two cables of a ring might need to be placed next to each other). ...s tape the ends of each circuit together ie LNE of upstairs lights or if a ring tape them as a pair. Labelling the tape also helps as the tape will probabl
    19 KB (3,370 words) - 10:23, 25 May 2023
  • ...d some of the wiring loom with the display, and thumb throttle. The Silver ring being part of the pedal rotation sensor. ]] ...elf, or fixed to the seat tube on the frame. The disc typically contains a ring of small magnets, and the sensor a couple of hall effect detectors to sense
    26 KB (4,901 words) - 01:39, 28 February 2024
  • ...there is a difference in rating between 30A fuses and 32A [[MCB]]s used on ring circuits.
    11 KB (1,743 words) - 09:10, 5 October 2022
  • ...ost are galvanised. Often there is a choice of smooth or ring shanked (the ring shanks are harder to drive, but also harder to pull out and so good for tas ...[[image:PaperCollatedClippedHeadNails.jpg|thumb|right|Paper collated, 90mm ring shanked framing nails with a clipped head]] From 50-90 mm with a point. Hea
    17 KB (2,845 words) - 17:23, 9 August 2013
  • : Ring shaped [[Fluorescent Lighting|fluorescent tube]] : rubber ring-shaped item that protects [[Cables|cables]] etc from the sharp edges of a h
    31 KB (4,494 words) - 09:57, 12 July 2019
  • ...5 models with tools, tools are changed by squeezing the sides of the metal ring while pulling the tool out
    6 KB (958 words) - 10:04, 5 November 2021
  • A single metal ring. These are often supplied with portable [[TV]]s. They're somewhat direction
    8 KB (1,260 words) - 22:17, 6 September 2014
  • ** Ensure there's a ring shank nail in each floorboard at each joist crossing When nailing floorboards back, ring shanked nails are much less prone to pulling out later than plain round or
    15 KB (2,432 words) - 05:52, 1 October 2014
  • ...ay round (neons show as 60.megohms? might be wrong on this). If you have a ring of sockets, break it half-way and check each half, then quarter it, go on u
    6 KB (1,076 words) - 18:50, 26 October 2022
  • * RING doorbell, and associated accounts
    8 KB (1,230 words) - 17:29, 21 August 2022
  • ...EPL]Telephone related sites. How to wire up 'n' phones and still have them ring! And lots of other phone stuff too. ...g.org/cgi-bin/webring?ring=wood&list Woodworking Webring] Woodworking web ring (Mostly US)
    19 KB (2,776 words) - 21:21, 24 March 2020
  • The 40mm ring pull handles were from screwfix - about the only thing I could find that ma
    9 KB (1,586 words) - 22:58, 6 May 2023

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)